Sharp #LMV-50-DVS, Vertical Turret Mill, 9" x 50" table, 36.6" X, 12" Y, 5" Z, 12" ram travel, 16" vertical knee travel, 3 HP, 4500 RPM, 6" Kurt vise, 3-axis Newall digital read out, 220 V.

Here We Have
Sharp LMV-50 DVS Vertical Knee Mill W/ Digital Variable Speed, 3 Axis Acu-Rite DRO
Note: Can be run on 1 phase Power 220v
Specifications
Table Size: 9” x 50”
T-slots (No., Size, Pitch): 3, 5/8”, 2.5”
Table Travel: X Longitudinal: 36.6”
Table travel: Y Cross: 12”
Quill travel: Z Vertical: 5”
Ram Travel: 12”
Knee travel: Vertical: 16”
Spindle Center to Column: 6.75” – 18.5”
Spindle Nose to Tabletop: 2.125” – 18”
Spindle Nose Taper: R-8
Spindle Variable Speed Range: 60 – 4500 rpm
Spindle Motor: 220V, 3 HP
Quill Feed (Inch/Rev) (3 speeds): .0015”, .003”, .006”
Quill Diameter: 3.375”
Head Swivel Angle: 360°
Head Tilt Angle (L/R): 45°
Head Tilt Angle (Up/Down): 45°
Floor Area (W x D x H): 7’ x 6.5’ x 6.75’
Approximate Weight: 2,500 lbs.
Power Consumption (220V): 3 KVA/8 amp
Complete With:
New Right Angle Head
3 Axis Acu-Rite DRO
6” Work Vise
2 Work Lights
1 Shot Lube
Chrome Ways
New Set Work Hold Downs
R-8 Collets & Holder