12 gauge x 4' Doelger & Kirsten #25-4, mechanical press brake, 7/8" die, 40 SPM, flywheel drive, adjustable slide & stroke, manual back gauge

$2,300 USD

Request Formal Quote

Built for precision sheet metal bending, this mechanical press brake delivers a 4-foot bed capacity rated at 12 gauge over a 7/8" die, making it well-suited for consistent forming work in fabrication shops. A flywheel-driven mechanical stroke design allows for repeatable cycle timing at up to 40 strokes per minute, while the adjustable slide and stroke settings give operators control over bend depth and shut height for varied material thicknesses. Priced to sell quickly, as the owner is clearing floor space for incoming equipment this is a strong opportunity to add proven press brake capacity at a value price point.

Please note: Additional tooling (dies, punches, or related forming accessories) may be available separately at the time of purchase but is not included with this listing by default.

Safety Accessory Notice Please Read Before Purchasing:

This equipment is sold as-is, in used industrial condition, and does not include modern safety guards, light curtains, interlocks, or other safety accessories that may be required under current workplace safety standards. It is the sole responsibility of the purchaser to evaluate the equipment and install any safety devices, guarding, or retrofits necessary to meet applicable workplace, OSHA, or local safety requirements prior to operation. By purchasing this equipment, the buyer assumes full responsibility for its safe setup, use, and compliance with all applicable regulations.

MILWAUKEE / DOELGER & KIRSTEN 25-4


EQUIPPED WITH:

Milwaukee Doelger & Kirsten Press Brake, Model 25-4
Integrated motor and drive assembly
Gould ITE safety disconnect switch (30A, 240V, 3-phase)
Manual back gauge/positioning bar
Base stand assembly

(Tooling, dies, and punches shown or referenced are not included unless separately negotiated at time of sale.)