10"/6" AET, dual diameter film reclaim extruder, 32:1 L/D, vented, 400 HP AC, Yaskawa drive, Koellmann gear reducer, Xaloy EH80 8" screen changer

AET 10/6 Dual Diamter Extruder
DESCRIPTION
AET dual diameter 10-6 32:1 L/D 50 centerline height film reclaim extruder with Koellmann gear double reduction gear reducer, with oil pump, heat exchanger cooling system, cast water cooled feed throat with grooved hardened horizontal liner, 4140 SAE barrel with bimetallic liner, vented with vent assembly, 10 barrel zones with cast in aluminum heaters all wired into a extruder base mounted junction box, water cooled heaters with closed loop cooling system including 3HP pump, heat exchanger and stainless steel tank, removable stainless steel barrel guards, screw is a 4140 steel with Colmonoy hard faced flight 10 diameter 7:1 L/D feed section tapering to 6, 400HP 460V AC 1800RPM motor with blower and filter assembly directly coupled to the Koellmann gear reducer and controlled by a Yaskawa AC drive controller in control panel, panel is a NEMA 12 double door panel with 400 AMP breaker, solid state contractors for each individual zone with 110V control transformer, includes digital melt and pressure indicator and melt probe, includes Xaloy EH80 8 hydraulic 2-position slide plate screen changer mounted horizontally to barrel with hydraulic power pack and accumulator & controls. 2,000 pounds/h avg output, AET extruder was built in 2014 but installed NOS in 2019.
NOTE: THIS IS FOR SHREDDED FILM RECLAIM, NOT PELLETS/REGRIND.