|Shut Height: 28.5"|
Stock #: 710-02223
Price: Request a Price
Slide Area: 96″ x 48″
Shut Height: 28.5″ over bed
Windows: 25″ wide
Floor Standing: Yes
Overall Weight: 110,000 #
Location: Livonia, Mi
Machine Stock Number: 710-02223
Bolster Plate: 6″ thick t-slotted plate
Slide Adjustment: 6″
-Air Clutch and Brake
-STI Light Curtains
-Imco Tonnage Monitor
-Allen Bradley Panelview 1000 Screen
-8 Point Gibbing
-Dual Ross Air Valve
Rebuild Work to Be Performed;
Rygate LLC is willing to incur the cost to remove the slide assembly and ship the slide to the press rebuilder. The slide will have every component removed from the slide. Slide will be set on a boring mill, check the bottom for flat, recut to flat if necessary, check bronze wear strips for squareness, skim cut and reflake as required. Clean up and machine all machined surfaces to flat. Deburr worm teeth and polish worm shafts, furnish new worm shaft bearings. Skim cut Knuckle Seat; refit to knuck. Line bore wrist pin bores. Bore Links to clean up, replace bronze bushing material; furnish and install. Reassemble Slide assembly and test run. Provide servicemen to reinstall slide and level slide and set gibbs at Rygate LLC Facility.
Also, included is the replacement of the connection arm bushings, which connect the slide to the crown assembly. They will be replaced so as to allow the press to have ‘like-new’ clearances throughout.
Both the clutch shaft and flywheel shaft will be removed and shipped to the press rebuilder. There they will have all new bearings and bushings installed. All bores, for the bushings, will be qualified and machined for proper clearance before installing the new bushings. When complete, both shafts will have all new bushings and bearings throughout.
Set of (4) Vibration Isolation Levelers is included with the press. They are the original mounts that go with the press.
Modification and replace all main Recirculating Lubrication Components i.e., (2) New MSP Blocks, to replace MR Blocks, New lubrication pump and motor, add prox switches (to monitor lubrication system through Toledo Updated control), Test system and make sure that all lubrication points are receiving proper oil.
All gears have been inspected, by two mechanical press rebuilders in the Detroit area, Superb Machine Repair and Laporte Industrial Inc. We pulled gear covers and they determined that all gears are in good/very good condition, with very minimal wear.
Includes a new Toledo Integrated Technologies PLC Clutch/Brake control. The PLC will be installed and integrated with the existing Allen Bradley AC Inverter Variable Speed Drive and motor starters and runoff at the Livonia facility.